4
PROCEDURES BEFORE OPERATION
This chapter describes the procedures before operation.
1.
Installing a battery
Install a battery to the CPU module as needed. (Page 24 Installing a Battery)
2.
Inserting an SD memory card
Insert an SD memory card to the CPU module as needed. (Page 26 Inserting and Removing an SD Memory Card)
3.
Wiring of each device
Wire each device.
(MELSEC iQ-F FX5U User's Manual (Hardware))
(MELSEC iQ-F FX5UC User's Manual (Hardware))
4.
Connecting a personal computer
Connect the CPU module to a personal computer that has an engineering tool installed. (Page 28 Connecting a Personal
Computer)
5.
Powering on the system
Check the following items, and then power on the system.
• A cable is correctly connected to the power supply.
• Power supply voltage is within the specified range.
• The CPU module is in the STOP state.
6.
Initializing the CPU module
Initialize the CPU module using the engineering tool. (Page 31 Initializing the CPU Module)
7.
Setting parameters
Set system parameters, CPU parameters, and module parameters. (Page 32 Setting Parameters)
When the following function of the CPU module are used, parameters of the function must be set.
• When the built-in Ethernet function is used
• When a function that uses SD memory card is used
• When any intelligent function module is mounted
8.
Programming
Create a program using the engineering tool. (Page 33 Programming)
9.
Writing data to the programmable controller
Write the parameters and the program created by using the engineering tool to the programmable controller. (Page 37
Writing Data to the CPU Module)
10.
Resetting the CPU module
Restart the system in either of the following ways.
• Power off and on the system.
• Reset the CPU module. (Page 38 Resetting the CPU Module)
11.
Executing the program
Run the CPU module, and check that the P.RUN LED turns on. (Page 38 Executing the Program)
12.
Monitoring the program
Check that the program operates normally using the engineering tool. (Page 39 Monitoring the Program)
Precautions
Do not write a program with more than 64 k steps to the CPU module firmware version earlier than 1.100. The program does
not operate normally.
4 PROCEDURES BEFORE OPERATION
4
23