Danfoss CDS803 Quick Manual page 24

Quick Guide
1 1
Changes made
Changes Made lists all parameters changed from default
settings.
•
The list shows only parameters which have been
changed in the current edit set-up.
•
Parameters which have been reset to default
values are not listed.
•
The message Empty indicates that no parameters
have been changed.
To change parameter settings
1. Press [Menu] key to enter the Quick Menu until
indicator in display is placed above Quick Menu.
2.
Press [
compressor set-up or changes made, then press
[OK].
3.
Press [
in the Quick Menu.
4. Press [OK] to select a parameter.
5.
Press [
setting.
6. Press [OK] to accept the change.
7. Press either [Back] twice to enter Status, or press
[Menu] once to enter Main Menu.
The Main Menu accesses all parameters
1. Press [Menu] until indicator in display is placed
above Main Menu.
2.
Press [
groups.
3. Press [Ok] to select a parameter group.
4.
Press [
in the specific group.
5. Press [Ok] to select the parameter.
6.
Press [
22
Quick Guide
▲ ▼
] [ ] to select wizard, closed-loop set-up,
▲ ▼
] [ ] to browse through the parameters
▲ ▼
] [ ] to change the value of a parameter
▲ ▼
] [ ] to browse through the parameter
▲ ▼
] [ ] to browse through the parameters
▲ ▼
] [ ] to set/change the parameter value.
Danfoss A/S © Rev. 08/2014 All rights reserved. MG18M122