Danfoss CDS803 Quick Manual page 31

Quick Guide
Digital inputs
Programmable digital inputs
Terminal number
Logic
Voltage level
Voltage level, logic 0 PNP
Voltage level, logic 1 PNP
Voltage level, logic 0 NPN
Voltage level, logic 1 NPN
Maximum voltage on input
Input resistance, R
i
Digital input 29 as thermistor input
Digital input 29 as Pulse input
Analog inputs
Number of analog inputs
Terminal number
Terminal 53 mode
Terminal 54 mode
Voltage level
Input resistance, R
i
Maximum voltage
Current level
Input resistance, R
i
Maximum current
Analog output
Number of programmable analog outputs
Terminal number
Current range at analog output
Maximum load to common at analog output
Maximum voltage at analog output
Accuracy on analog output
Resolution on analog output
1) Terminal 42 and 45 can also be programmed as digital outputs.
Digital output
Number of digital outputs
Terminal number
Voltage level at digital output
Maximum output current at digital output
Maximum load at digital output
1) Terminals 42 and 45 can also be programmed as analog output.
Control card, RS-485 serial communication
Terminal number
Terminal number
Control card, 24 V DC output
Terminal number
Maximum load
MG18M122
Quick Guide
Maximum frequency 32 kHz push-pull-driven & 5 kHz (O.C.)
Danfoss A/S © Rev. 08/2014 All rights reserved.
18, 19, 27, 29
PNP or NPN
0–24 V DC
<5 V DC
>10 V DC
>19 V DC
<14 V DC
28 V DC
Approx. 4 kΩ
Fault: >2.9 kΩ and no fault: <800 Ω
Parameter 6-19: 1=voltage, 0=current
Parameter 6-29: 1=voltage, 0=current
Approx. 10 kΩ
0/4 to 20 mA (scalable)
0/4–20 mA
Maximum error: 0.4% of full scale
68 (P, TX+, RX+), 69 (N, TX-, RX-)
61 common for terminals 68 and 69
1 1
4
2
53, 54
0–10 V
20 V
<500 Ω
29 mA
2
42, 45 1)
500 Ω
17 V
10 bit
2
1)
42, 45
17 V
20 mA
1 kΩ
12
80 mA
29