Setting Wmb260Ac As Access Point (Ap) - Aztech WMB260AC User Manual

NOTE:
1. It is recommended to place your mesh nodes between the Mesh Controller
and the place where dead zone is experienced
2. The AIR Router can have both WMB260AC Whole-Home Wi-Fi Mesh System
and another AIR Router as mesh nodes in one mesh system.

Setting WMB260AC as Access Point (AP)

To setup the WMB260AC as AP, find an area near the data point or the main router
and near an electrical outlet. Alternatively, you may wish to use an Ethernet cable
to connect the WMB260AC to your router for further distance (only if you do not
have/wish to use the data point).
Manual Setup
a. Factory reset the WMB260AC router.
b. Power ON your WMB260AC by connecting and plugging its power adapter to
a power outlet.
c. Connect PC/Laptop to the WMB260AC through Ethernet.
Setting up the Extended Network
a. Launch the web browser and access the Web User Interface via
http://10.0.10.254.
b. Set the SSID (Network Name) and Network Password of WMB260AC. You may
choose to set the SSID and Network Password the same as your main router's
SSID and Network Password.
c. Connect your Data Point/main router to the one of WMB260AC's Ethernet
port using an Ethernet cable.
NOTE: The POWER and WIRELESS LEDs must be solid Blue.
40