TDR-AC CONTENTS INTRODUCTION ......................5 General ..........................5 Identification of the unit ..................... 5 Pictograms and symbols ....................5 Safety instructions ......................6 1.4.1 General ........................6 1.4.2 Moving ......................... 7 Hygiene ..........................7 Service and technical support ................... 7 Storage ..........................
Page 4
TDR-AC Pre-heating ........................19 While cooking ......................... 20 Adding extra time to the active program ................20 Interrupt a program ......................21 Set the timer (optional) ....................21 Reset alarm signal ......................21 Power down ........................21 SETTINGS ........................22 General ...........................
INTRODUCTION General This manual is intended for the user of the TDR-AC (Turbo Deli Rotisserie with cleaning feature). The features and controls are being described, along with directions for the safest and most efficient use, in order to guarantee a long life of the unit.
TDR-AC Safety instructions WARNING The outside of the unit can be very hot. WARNING The maximum load on top of the unit may never exceed 50 kg (110 lbs). WARNING Risk of slippery floor: Spills may cause slippery surfaces, clean-up promptly.
TDR-AC 1.4.2 Moving When moving the unit: Before moving the unit, first switch off the mains voltage by pulling the plug from the wall socket and empty the fat collecting container. After that, cool-down the unit for at least ten minutes.
Communication through USB enables easy read-out, re-work and creating of programs via a PC. For this, special software is available at Fri-Jado. The unit has an automated cleaning program that cleanses the unit.
TDR-AC INSTALLATION AND FIRST USE All packing materials used for this unit are suited for recycling. After unpacking, check the state of the unit. In case of damage, store the packing material, and contact the transporter within fifteen working days after receiving the goods.
TDR-AC Installation and positioning WARNING Position the unit on a flat and horizontal surface. A temporally inclined plane of maximum 5° is allowed. Positioning: The user must have sufficient freedom of movement to properly operate the unit. The ambient temperature of the unit must be between 10 and 30 °C (50 and 86 °F).
TDR-AC First use When using the unit for the first time, clean the interior thoroughly with soap suds and heat up the unit, see section 3.3.1. After commissioning discoloration of the cooking/grilling area can occur. ➊ ➋ ➌ ➍ ➎...
TDR-AC OPERATION AND USE Control Panel SELECTION BUTTONS DISPLAY SCREEN START ROTOR BUTTON PAUSE OK BUTTON STOP CANCEL ROTATION PAD (DIAL) Button Function SELECTION BUTTONS Selecting tabs in display screen. ON / OFF Switching the unit on and off. START / PAUSE Starting and ending a program.
Whole uncut chickens should always be grilled using the meat forks. This way their natural fat will baste each other, giving a perfectly slender cooking result. Refer to the You-Tube movie: “Fri-Jado instruction for binding and loading chicken”. For preparing chicken or any other poultry, you can work as follows.
TDR-AC 1. Insert one point of the meat fork through the chest at the position of the wings. Insert the other point through the drum sticks. Don’t forget to include the wings. 2. Leave some space between the products, for an even exposure and browning.
TDR-AC 4.3.3 Loading the rotisserie using meat baskets (accessory) If you are using meat baskets, act as follows: Attach the meat baskets to the appropriate pins. Whilst loading the unit with meat baskets, you must see to it, that the rotor gets evenly loaded, so that the mass of the products is evenly spread over de rotor, causing an equal balance.
TDR-AC 4.3.5 Loading the rotisserie using two different accessories. WARNING After loading the rotor, at least make ONE full rotation, and check whether the rotor can spin without obstructions. If you want to load the unit using two different accessories at the same time, always fill the rotor with ONE accessory fewer than the maximum allowed quantity.
3. Take the meat fork at its other end and take it out of the unit. 4. Remove the products from the meat fork. Refer to the You-Tube movie: “Fri-Jado instruction for unloading chicken from a rotisserie”. 4.5.2 Taking out the V-shape spit (accessory) For taking out the V-shape spit you can use the same principle as described in section 0.
TDR-AC Emptying grease container WARNING Check the grease container after each cooking process and empty already when about half full to avoid overflowing. WARNING Grease will be hot immediately after cooking. Allow grease to cool or use extreme caution and wear insulated gloves or safety mitts.
TDR-AC OPERATE Starting a program 1. Press the left-hand selection button. 2. Select the required program. The total duration of the program is shown in minutes next to the name of the program. 3. Press START/PAUSE. Use the rotation pad or arrow buttons to toggle between the programs.
TDR-AC While cooking WARNING Opening the door during a grilling program or a cleaning program causes the unit to stop and a warning is shown. The unit will continue when the door is closed. During the cooking process, the display shows a graph with the planned trajectory (orange time line) and the set temperature (light orange field).
TDR-AC Interrupt a program Interrupt temporarily: 1. Press START/PAUSE. 2. Press START/PAUSE again to resume the program. Interrupt definitely: 1. Press STOP/CANCEL. 2. Select “yes”. 3. Press OK. Set the timer (optional) This function allows the user to automatically start a program on a pre-determined date and time.
TDR-AC SETTINGS General The settings of the unit can be changed by using the control panel. There are three kinds of settings: Information Manager Service Information 6.2.1 Access 1. Activate the settings menu (right selection button). 2. Select “information”.
TDR-AC Manager The Manager menu is used to set the parameters. 6.3.1 Access 1. Activate the settings menu (right selection button). 2. Select “manager”. 3. Press OK. When a pin code has been set: 1. Use the rotation pad to enter the pin code.
TDR-AC PROGRAM General Your dealer has programs that are loaded into the unit by means of a computer. These programs vary with the composition of the product and the customer’s desire, and are customer dependent. You can protect the cooking programs and the ‘secured settings’ by changing pin code “0000” in the menu, into any other pin code.
TDR-AC 7.2.2 Programming cooking step The table on the screen contains the following columns: Time duration Temperature Row 1 shows step 1, row 2 shows step 2, etc. There can be no more than 9 steps. A selected cell shows an orange frame. To alter a cell, it needs to be ‘opened’...
TDR-AC Edit programs 1. Select “Edit program”. 2. Press OK. 3. Select the required program. 4. Press OK. Edit the program name 1. Select the position of the character. 2. Change the character using the rotation pad. 3. Use a ‘blank’ to erase a character.
TDR-AC Deleting programs Deleting of a program cannot be undone. 1. Select “delete program”. 2. Press OK. 3. Select the program. 4. Press OK. 5. Check whether the program name matches the program you wish to delete. 6. Select “yes” if this is the case. Select “no” if not.
TDR-AC Sorting programs This function allows you to sort programs alphabetically. 1. Select “sorting alphabetically”. 2. Press OK. 3. Use arrows to select “yes”. 4. Press OK. 28 / 36...
TDR-AC CLEANING AND MAINTENANCE WARNING Appliance must be disconnected from the power supply during manual cleaning or maintenance and when replacing parts. Do not use aggressive or abrasive materials. These will damage the surface which will make it more difficult to remove dirt.
8. Inspect the unit and clean it manually if necessary. 9. Replace the bottom filter and tablet dispenser. The unit is now ready for use. Contact your supplier for the appropriate Fri-Jado Rotisserie Cleaning Tablets. 30 / 36...
TDR-AC MALFUNCTIONS AND SERVICE Before you contact your supplier/dealer in case of a malfunction, there are some items you can check yourself: Is the power supply working properly? Check fuses and differential switch. Has the timer clock been properly set?
TDR-AC TECHNICAL SPECIFICATIONS WARNING Consult the identification plate to get the proper specifications of the unit. The electrical data may vary from country to country. European Models TDR-AC Dimensions Width 1045 Depth Height 1795 Weight Gross Maximum ambient °C temperature...
Need help?
Do you have a question about the TDR-AC and is the answer not in the manual?
Questions and answers