Fire Sense 60368 Manual page 6

ASSEMBlY
3
Attach the lower Post
you have tightened the bolts holding the Post Supports
to the Base J , align the holes in the lower Post
holes on the tops of the Post Supports and insert a large Bolt
through the hole in the Post Support. Secure with a Small
Flange Nut. Repeat this in the 5 remaining holes (6 holes
total—2 for each Post Support piece). Hand tighten initially then
tighten with the Wrench when all bolts have been inserted.
Hardware Used: 6x Large Bolt | 6x Small Flange Nut
4
Attach Upper Post
F
two pieces of the post together.
5
Slide Tank Housing D
Posts F / G and down over the Post Supports
Tank Housing on the Base
6
Attach Reflector Studs to the top of the Head
Assembly C . Insert 1 Reflector Stud through 1 large Flat
Washer and into the hole on the top of the Head Assembly
Tighten stud securely. Repeat with the other 2 Reflector Studs.
Hardware Used: 3x Reflector Stud
Contact us for assistance: (866) 985-7877 | www.wtliving.com
G to the Post Supports I
G with the
to lower Post by screwing the
G
over the assembled Upper/lower
I
.
J
3x Large Flat Washer
. Once
I
. Rest the
C .
6