Fire Sense 60368 Manual page 7

ASSEMBlY
7
Attach Head Assembly
Gas Hose E down into Upper/lower Posts
align 4 small holes on the Head Assembly
holes in the Upper Post
F
lock Washers through the aligned 4 holes and tighten
securely with the wrench.
Hardware Used: 4 x Small Bolt w/Lock Washer
8
Install Reflector. NOTE: MAKE SURE TO REMOVE
PROTECTIVE PlASTIC COVER ON REFlECTOR PIECES
PRIOR TO ASSEMBlY!
Assembly Tip: If necessary for proper alignment of reflector
sections, loosen each screw prior to further assembly and
retighten after sections are aligned.
Slide two Reflector Panels
Screw on Cap Nut loosely.
Repeat with the other Reflector Panels
Slide Reflector Center Cap
Panels A . Insert one Small Screw and screw on Cap Nut
loosely. Repeat with two more Small Screws and Cap Nuts
to complete reflector assembly. Fully tighten all screws and
cap nuts.
Hardware Used: 12x Small Screw | 12x Cap Nut
Contact us for assistance: (866) 985-7877 | www.wtliving.com
C to Upper Post F . Route
F / G
with 4 Small
C
. Insert the 4 Small Bolts with
together. Insert one Small Screw.
A
A .
B onto assembled Reflector
and
7