Calibration :State; Calibration N :State - HP E1328A User Manual

Example
n
CALibration :STATe
Parameters
Comments
Example
CALibrationn:STATe?
Chapter 5
Entering Channel 4 Measurement Data.
This command enters the minimum, default, and maximum measured values
channel 4 output during an electronic adjustment procedure.
CAL4:CURR -0.02359, 0.00012, +0.02405
CALibration n :STATe <
specific channel.
Parameter Name
n
CALibration
mode
< >
•
Channel Number: Select only one channel at a time.
•
Related Commands:
[SOURce:]VOLTage n,
•
*RST Condition:
CALibration:STATe 1
Setting Channel 3 to Non-Calibrated Mode.
CAL3:STAT OFF
CALibration n :STATe?
mode of operation. 1 (one) indicates operating under calibrated mode, and
indicates operating under non-calibrated mode.
mode > enables or disables the calibrated mode for a
Parameter Type Range of Values
keyword
boolean 0 | 1 | ON | OFF
n ,
CALibration :CURRent
[SOURce:]CURRent n
Set channel 3 mode to non-calibrated output.
queries a specific channel about the currently selected
HP E1328A Command Reference
Default Values
1, 2, 3, or 4
1 | ON
n ,
CALibration :VOLTage
1
0 (zero)
43