Table of Contents
Advertisement
Subsystem Syntax
DISPlay:MONitor:CHANnel
Parameters
Comments
Example
Chapter 5
The
subsystem monitors the channel state of a selected module in a
DISPlay
mainframe. This command operates with mainframes that have a display, such as
the HP E1301A Mainframe.
DISPlay
:MONitor
:CHANnel <
:CHANnel? <
[:STATe] <
:STRing?
DISPlay:MONitor:CHANnel <
channel to be monitored when the monitor mode is enabled.
Parameter Name
Parameter Type
<
channel
>
•
Selecting Monitor Channel Values: When using the
command, numbers
1
to selecting a specific channel, four other values can be entered.
selects channel 1,
MINimum
automatic mode where the last channel changed is displayed.
•
Monitor Mode on an HP 1301A Mainframe Display: Selecting the channel
causes the information to be displayed on the mainframe's front panel. The
DISPlay:MONitor:STRing?
the computer. The following shows the monitor mode display string on the
display of an HP E1301A Mainframe:
CHAN1 10.00000E01 VOLT, CAL 1
The example above shows channel 1, 10 Vdc, in the calibrated mode.
•
Related Commands:
Selecting Channel 1 for Monitoring.
DISP:MON:CHAN 1
channel
| MIN | MAX | DEF | AUTO>
channel
>
mode
>
channel
| MIN | MAX | DEF | AUTO>
Range of Values
numeric
1 to 4 | DEF | MIN | MAX | AUTO
to
select a specific channel to be monitored. In addition
4
selects channel 4, and
MAXimum
command must be used to display the information on
DISPlay:MONitor[:STATe]
HP E1328A Command Reference
DISPlay
selects the
Default Values
1
DISPlay:MONitor:CHANnel
DEFault
and
activates the
AUTO
45
Advertisement
Table of Contents
