HP E1328A User Manual page 25

Comments
WARNING
Chapter 3
Figure 3-4. Extending Voltage Output Range
•
Sense Terminals. Use of remote sensing is recommended to
compensate for voltage drops in the test leads. This ensures an
accurate voltage is present at the load. If not in use, do not make any
connection to the SENSE terminals.
•
Compliance Current. The maximum current available when
outputting a voltage is 24 mAdc. This means, that at 12 Vdc, the
load resistance should be at least 500Ω. See Chapter 4 for further
explanation on compliance current and load resistance.
•
Isolation. Channel-to-channel or channel-to-chassis isolation is
rated at 250 Vrms (350 Vdc/ac peak).
Do not exceed the rated isolation voltage. Damage may result if
channels of the same D/A Converter are connected to separate phases
of 3-phase power lines.
•
Incorrect Jumper Setting. If a channel is configured for current
and instructed to output voltage, an error will be generated.
Using the HP E1328A 25