Troubles subject to troubleshooting are classified into those shown on the display (warning, error, and service call) and those not shown on the display.

The code of warning and error is shown by combining alphanumeric characters of eight digits and four digits.

The code of service call error is shown by the initial character of "E" and combining alphanumeric characters of three digits and four digits.

No code number is displayed when a warning occurs. Selecting [SERVICE MODE] > [DISPLAY] > [WARNING] in service mode allows you to check the warning

log.

2. Precautions for Troubleshooting

1) Check the environmental conditions and the media used for printing.

2) Before performing troubleshooting, make sure that all connectors and cables are connected properly.

3) When servicing the printer with the external cover removed and the AC power supplied, be extremely careful to avoid electric shock and shorting electrical

devices.

4) In the following sections, the troubleshooting steps are described such that the component related to the most probable cause of the problem will be repaired or

replaced first, being followed by components with less problem probability. If multiple components have the same problem probability, the steps are described

beginning with the easiest one.

After performing each step, check to see if the problem has been resolved by making test prints. If the problem persists, proceed to the next step.

5) After completion of the troubleshooting, check that all connectors and cables have been reconnected and screws have been tightened firmly.

6) Whenever you have performed replacement or repair services, make test prints to check whether the problem has been resolved.

7) When connecting with the printer by using the LAN cable at the service working, be sure to enter the service mode to recognize the printer correctly.

6-1

Table of Contents