Do not remove the printhead once they are installed, as this may cause the nozzles to dry out or accumulate foreign matter. Also the head must be capped and stay

in the carriage while transporting the printer. In spite of this precaution, shocks incurred during transportation can still damage the printhead. Print the "Nozzle

Check" before moving the printer, print the "Nozzle Check" after installing in a new location, and compare the two printouts. If any deterioration is evident in the

output quality, replace the printhead with new ones.

This subsection describes how to transport the printer.

When moving the printer to another place on the same floor of the building, move it slowly so that it does not receive any shocks. Follow the steps shown in "1.

Moving the printer on the same floor with no difference in grade".

When moving it elsewhere, follow the steps shown in "2. How to transport the printer to a different floor".

- When lifting or moving the printer, be sure to hold the left and right and rear carrying handles of the printer. The printer may be unsteady if you hold it at other

positions, which poses a risk of injury from dropping the printer.

- The printer main unit weights approximately 43kg. When moving the printer, have at least three people hold it from left and right and rear side taking care not to

hurt their back.

F-3-1

F-3-2

Chapter 3

0032-0543

3-1

Table of Contents