Canon iPF671 Service Manual page 218

Chapter 6
Code
(last 4 digits)
200F This paper
cannot be used.
Check supported
paper sizes.
This paper
cannot be used.
Check supported
paper sizes.
Load/Eject: Change Paper
2010 Paper loaded askew.
Press Load/Eject
and reload the
paper.
Paper loaded askew.
Reload the paper.
Paper loaded askew.
Lift the
release lever.
Paper loaded askew.
Lift the release
lever and reload
the paper.
Paper loaded askew.
Press OK and
reload the paper.
Paper loaded askew
Lift the release lever.
2015 Cannot cut paper.
Press Load/Eject
and reload the
paper.
Cannot cut paper.
Reload the paper.
Cannot cut paper.
Lift the release
lever and reload
the paper.
Paper cutting
failed. Lift the
release lever.
2016 No sheets.
Press Load/Eject
and reload the
paper.
No sheets.
Lift the release
lever and reload the sheets.
The paper is too
small.
Check paper size.
Sheet removed.
Lift the release
lever.
Paper jam.
Press Load/Eject and reload
the
paper.
Paper jam.
Manually rewind roll
all the way.
Paper jam.
Manually rewind roll
all the way
and press OK.
Cannot feed paper
Lift the release
lever and reload paper.
Cannot feed paper.
Reload the paper.
Cannot feed paper.
Press Load/Eject
and reload the
paper.
6-8
Panel display Panel display
(Large LCD) (Small LCD)
Paper Size
Please Check
Paper Too Large
Paper Too Large
Please Check
Press Online Key
and Reload
Paper Askew
Please Reload
Paper Skew
Paper Loaded
Crooked
Press Online Key
and Reload
Paper loaded
askew.
Remove paper
<When small LCD 1>
Cutting Error
Please Cut Papr
<When small LCD 2>
Press (upper arrow) Key
to Release Paper
Sheets
Please Load
Sheet Not Loaded
Paper Jam
Press (upper arrow) Key
Paper Jam
Press (upper arrow) Key
Paper Eject Err
Remove Paper
Explanation/Detection sequence
Paper mismatch (size)
Paper is too large
-The width and length of paper detected are
longer than the supported size (1.5%
margin).
-Cannot detect the leading edge of paper
even when the paper has been fed by 1300
mm for roll paper and by the size
mentioned above for cut sheet.
-Cannot detect the width of paper even
when the paper is fed by the size mentioned
above.
Skew (skewed right)
Paper is determined skewed as its edge is
read by the multisensor.
Cutting failure/jam detected due to a
cutting failure
An idle cutter unit or a cutter blade that is
too blunt to cut sheet has been detected by
the paper leading edge detection sequence.
Paper loosened out of position while
printing
The trailing edge of paper has been
detected at least 20 mm shorter than the
length of cut forms detected.
Jam while picking up, ejecting or printing
on paper
(A sequence of removing jams with the
pinch roller released is required)
Virtually all recovery errors that could
occur in connection with paper pickup are
handled.
Remedial Action
1. Check paper conditions (soiling,
tear-offs, residual paper chips, residual
trimming cuts, folds)/size.
2. Has the paper been fed successfully
(without slippage under a load or any
influence)?
3. Has the LF adjustment value set
correctly?
4. Hasn't the loaded paper shrunk to
below its margin in the particular
environment?
Reload the paper.
Reload the paper.
1. Open and close the release lever to
reload the paper.
2. Remove the paper once and then
refeed it.