- The printer is searched according to the setting of the [Specify Search Range] dialogue box after choosing the "[View]-[Specify Search Range]" of the main menu

to display the dialogue box. The five IP addresses at the maximum can register when searching by the IP address.

(3)-1 Choose the [Display PRINT INF] of the sub menu button or the "[Information]-[Display PRINT INF]" of the main menu when showing the PRINT INF.

- The data of PRINT INF is shown by the appointed application software.

(3)-2 Choose the [Display Status Print] of the sub menu button or the "[Information]-[Display Status Print]" of the main menu when showing the Status Print.

- The data of Status Print is shown by the appointed application software.

(3)-3 Choose the [Color Check] of the sub menu button or the "[Information]-[Color Check]" of the main menu when executing the color check.

- This mode judges the OK or NG by checking the color check data that measured by the multi sensor.

- Before executing the color check, need the following media to set to the printer.

Roll media of more than 10 inch width, or cut sheet of more than A4-size.

Paper type: Glossy Photo Paper 170gsm

- When executing the color check, the paper type that selected by the dialogue box must match with the paper type that set to the printer so that the check can

execute correctly.

MEMO:

- The application software used to show the data and the folder used to store the files can change by the "[Service]-[Setup]" of the main menu.

[1] This menu can change the folder used to store the file.

[2] This menu can change the application software (NotePad or WordPad) used to show the data.

- The printer name can add by the "[Service]-[Add Printer]" of the main menu.

F-6-3

F-6-4

F-6-5

Chapter 6

[1]

[2]