Table of Contents
Advertisement
5
START UP OF THE ADJUSTMENT MODE
Adjustment mode
All picture geometry and convergence adjustments are made while in the 'Adjustment mode'. Two possible ways to enter the adjustment
mode :
a) Using the RCU.
Press the ADJUST key.
The projector displays the path selection menu.
b) Using the local keypad.
Press the ADJUST key.
The projector displays the General access menu .
Use the control disk to highlight enter ADJUST and press ENTER . The path
selection menu will be displayed.
Note : to adjust the Analog picture control while in the 'Adjustment mode', press
the ADJUST key. The next General Access menu will be displayed.
Push the control disk up or down to select the analog control to be adjusted and
press the ENTER key to confirm.
When the analog control is adjusted the projector returns automatically to the
General access menu. When you want to return to the Adjustment mode, press
EXIT , otherwise select quit ADJUST and press ENTER to return to operational
mode.
You are now in the 'Adjustment mode' . The control disk is used to make menu
selections and also vertical and horizontal adjustments. The ENTER and EXIT
keys are used to move forward and backward through the menu structure. The
ADJUST key can be used to terminate the adjustment mode while a path
selection menu (head menu) is displayed.
There are 5 possible paths to follow once in the Adjustment mode. They are :
INSTALLATION - Installation should be selected if the projector has been
relocated and/or a different screen size is desired.
When selecting 'Installation', the user or operator will be warned to call a qualified
technician to perform the installation procedure (see example of projected
warning on next page).
GUIDED - Guided should be selected if the user intends to perform a complete
alignment of the projected image. All of the necessary geometry and conver-
gence adjustments are made in a predetermined sequence.
5975977 BARCODATA 708 260597
Safety Instructions
ADJUST
EXIT
STANDBY
ENTER
GENERAL ACCESS
SHARPNESS
TINT
COLOR
5
6
BRIGHTNESS
3
4
CONTRAST
1
2
Enter ADJUST
Select with
,
or
then <ENTER>.
<EXIT> to return
GENERAL ACCESS
SHARPNESS
TINT
COLOR
BRIGHTNESS
CONTRAST
quit ADJUST
Select with
,
or
then <ENTER>.
<EXIT> to return
ADJUSTMENT MODE
Select a path from
below:
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
IRIS
source 1
Select with
or
then <ENTER>
<EXIT> to return
643
5-1
Advertisement
Table of Contents
