Table of Contents
Advertisement
Safety Instructions
RANDOM ACCESS - Random Access should be selected if the user intends to make
only a few adjustments.
SERVICE - Service should be selected if the user intends to delete blocks, change
password or apply information.
IRIS - This selection will only be available when the autoconvergence unit IRIS is
connected to the projector.
While in Guided or Random Access adjustment Mode, the user may use an external
source, an internally generated genlocked pattern or an internally generated
multifrequency cross hatch pattern as a setup pattern.
Warning during the start up of the installation mode.
Some items in the Adjustment mode are password protected. While selecting such
an item, the projector asks you to enter your password. (Password protection is only
available when the password DIP switch on the controller module is in the ON
position. Contact a BARCO authorized technician when no password is requested
during the adjustment procedure and password protection is desired.)
Your password contains 4 digits.
a) Adjusting the projector with the RCU.
Enter the digits with the numeric keys on the RCU.
Example : 2 3 1 9
For each digit entered, a 'X' appears on the screen under the displayed text 'enter
password'.
When your password is correct, you get access to the 'Adjustment mode'.
When the entered password is wrong, The message 'Wrong password !!!' will be
displayed. The projector stays on the previous selected item.
Factory programmed
password : 0000
b) adjusting the projector with the local keypad.
When the 'compose password' menu is displayed, select with control disk the first
digit of your password and press ENTER . Continue by selecting the second digit
with the control disk and press ENTER . Handle in the same way for the third and
fourth digit.
When your password is correct, you get access to the 'Adjustment mode'.
When the entered password is wrong, the message 'Wrong password' will be
displayed.
Once the password is correctly entered, all other password protected items are
accessible without re-entering your password.
When re-entering the adjustment mode, it will be necessary to enter your password
again when selecting a password protected item.
5-2
WARNING
RISK OF ELECTRICAL SHOCK
NO USER ADJUSTABLE PARTS
INSIDE
THE FOLLOWING
INSTALLATION MENUS
ARE RESERVED TO,
AND TO BE PERFORMED ONLY
BY BARCO PERSONNEL, OR
BARCO AUTHORIZED DEALERS
IF QUALIFIED, PRESS
<ENTER> TO CONTINUE, OR
IF NOT, <EXIT> TO RETURN.
enter
password
xxxx
WRONG
PASSWORD
!!!
COMPOSE
PASSWORD
???
7 8 9
4 5 6
1 2 3
0
Select with
,
or
then <ENTER>
<EXIT> to return
5975977 BARCODATA 708 260597
197
198
Advertisement
Table of Contents
