Quantum DXi4520 Installation And Configuration Manual page 30

DXi4000 Installation and Configuration Guide
Figure 24 NAS Wizard:
Confirm
28
13 Complete the NAS wizard:
a Review the settings you selected to make sure they are correct. If necessary, click
Previous to return to a previous step to make changes.
b To make changes to a NAS share you added, first select the share and click
Delete to delete the share. Then click Previous to return to the previous step
and add a new share.
c After you have confirmed all settings, click Finish. The NAS share is created and
becomes available on the Windows network.
14 To verify the NAS share:
a On a computer on the same network as the DXi4000, click Start and then Run.
b Type: \\<IP address of the DXi4000>\<name of the NAS share>
c Press Enter.
The NAS share will display the NAS share in Windows Explorer if successful.
15 The DXi4000 is now ready to use for backup operation. The installation is successful
when you are able to backup data to the system. Here are the next steps you can
take:
• Quantum recommends enabling Email Reports after you install your DXi. When
enabled, Email Reports periodically sends system configuration and status
information to Quantum, including any software upgrades you have installed
using the Software Upgrade Utility. Quantum Support can use this information
to provide a better support experience in the future.
Initial Configuration