Quantum DXi4520 Installation And Configuration Manual page 20

DXi4000 Installation and Configuration Guide
18
4 Under General, enter the following network information as provided by your
network administrator:
a Enter the Hostname used to identify the DXi4000 system.
The Hostname cannot be blank and must contain only letters
[ A–Z, a–z ], numbers [ 0–9 ], hyphens [ - ], underscores [ _ ], and dots [ . ].
b (Optional) Enter the Default Gateway IP address.
Specifying a default gateway is optional if all access is local to a particular
subnet. For example, if the DXi4000 and all of its clients are on the same subnet,
you do not need to specify a default gateway.
Caution: Specifying a default gateway is required to enable connectivity
with all subnets other than those that the DXi4000 is directly
connected to. For example, if the DXi4000 and its clients are on
different subnets, you must specify a default gateway.
c (Optional) In the DNS Suffix Search List box, enter the local domain to search
first when resolving domain names.
The domain suffix is a single domain name. The domain name may contain only
letters (A–Z), numbers (0–9), dots (.), and hyphens (-).
d (Optional) In the Primary, Secondary, and Tertiary DNS IP Address boxes, enter
the IP address of up to three DNS servers used to resolve domain names and
translate them into IP addresses.
Caution: You must specify a DNS IP address if you plan to use hostname
format when configuring an NTP time server, outgoing e-mail
server, replication sources and targets, and other information.
5 Under IP Address Configuration > Bonding Details, configure each Ethernet port
as a separate network device:
a If necessary, click the Show link to show the bonding details table.
b In the Not Bonded row, make sure each Ethernet port is selected (eth2, eth3,
and so on).
c If necessary, click Update to save the changes you made to the Bonding Details
table.
6 Do not make any changes under IP Address Configuration > Interface Details
unless directed by your network administrator. (For more information about the
VLAN tag and MTU size options, see the "Network" section in the
DXi4000 User's Guide , 6-67092).
7 Under IP Address Configuration > IP Address Table, enter network information
for the eth2 device:
Note: Do not make any entries in the VLAN ID, External Host IP, NATed, or NAT
IP Address columns unless directed by your network administrator.
a Select the eth2 row in the table.
Quantum
Initial Configuration