Quantum DXi4520 Installation And Configuration Manual page 21

Figure 15 Getting Started
Wizard: Date & Time
Initial Configuration
b If necessary, click Add IP to enable entry in the IP Address box.
c Enter the following network information as provided by your network
administrator (all fields are required):
Caution: Make sure you enter the correct IP address information and that
you write this information down. If you enter the incorrect IP
address information and reboot, you will not be able to access the
system.
• IP Address - The IP address of the DXi4000.
• Netmask - The network mask of the DXi4000.
• Gateway - The gateway of the DXi4000. (This is usually not the same as the
default gateway.)
d Select the Any check box to allow all traffic types (management, replication, and
data) on the interface.
e Click Update to save the changes you made to the IP Address table.
8 Do not make any changes under IP Address Configuration > Routing Details
unless directed by your network administrator.
Note: If the DXi needs to communicate with another subnet that is not reachable
using the default gateway, a route must be added under the Routing
Details section. (For more information about interface routing, see the
"Network" section in the
9 Click Next to continue.
The Date & Time page displays (see
Quantum DXi4000 User's Guide
Figure 15).
DXi4000
, 6-67092).
19