Table of Contents
Advertisement
45
45
Image 4-4
Direct using of the RCU
Backlighting
When a button is pressed on the RCU, backlight is activated automatically. That allows the user to operate the remote control in a
dark room. Backlight is turned off automatically a few seconds after the last button is pressed.
4.8 Projector Address
Projector address
Address installed in the projector to be individually controlled.
Overview
The projector address can be set to any value between 0 and 9.
Why a projector address ?
As more than one projector or device which is remote controlled can be installed in a room, the separate projector or device should
be separately addressable with an RCU.
When the projector and another device have the same address, during controlling, interference is possible. To avoid that, set the
projector address on a not used address in the room.
How to set the projector address ?
1. Press The Address key (recessed key) with a pencil.
The projector displays a message box to announce that you can enter an address between 0 and 9.
2. Enter the address by pressing a digit key between 0 and 9.
The projector address and the address of the RCU will be changed to the new entered address.
3. Press EXIT to return to operational mode.
4.9 Controlling the projector
Input Selection
Key in the corresponding input with the digit keys on the RCU. The selected source will be displayed.
When an source is displayed and more sources are connected and switched on:
•
press ↑ key to display the previous source.
•
press ↓ key to display the next source.
When no previous or next source, the projector returns to the actual source (only when Auto search is on).
R5976763 CINEVERSUM 60/70 22042004
4. Getting Started
29
Advertisement
Table of Contents
