GE ADTS542F User Manual page 71

ADTS542F/552F/553F/554F User Manual 3-37
4
5
6
F 3-27 S
IGURE ELECT TEST PROCEDURE STEP
7. Use the up/down arrows (5) to select the desired procedural step.
8. If required, use the control (6) to toggle between Measure and Control modes.
9. When CONTROL mode is selected, the screen changes to CONTROL and shows the actual
measurement and rate.
Creating custom test sequences
These instructions advise how customers may save correctly formatted Comma Separated
Variable (.CSV) files, ready to be loading to the ADTS Touch. These files are designed in spread
sheet format using Excel templates.
Loading new test sequence files can be accomplished by file transfer from a PC to the operating
system of the ADTS Touch. It provides an environment very similar to Windows File Explorer.
The data presented on each screen or table of the test sequence is drawn from a single data source
file. This file uses simple numeric data fields separated by commas, and is known as .CSV format. Files
of this type may be easily viewed and edited using a spread sheet program such as Excel. Files would
normally be saved with a meaningful name to assist easy identification and selection.
The example below identifies the areas or 'fields' of the screen where user entries from the CSV file are
used to format the screen layout and specific test information.
K0553 Revision C