Glossary - GE ADTS542F User Manual

16
The terminology used in this manual is specific and individual interpretation must not be introduced. The
terms are defined as follows:

Glossary

Adjust To bring to a more satisfactory state; to manipulate controls, levers, linkages, etc. to return equip-
ment from an out-of-tolerance condition to an in-tolerance condition.
Align To bring into line; to line up; to bring into precise adjustment, correct relative position or coinci-
dence.
Assemble To fit and secure together the several parts of; to make or form by combining parts.
Calibrate To determine accuracy, deviation or variation by special measurement or by comparison with a
standard.
Check Make a comparison of a measure of time, pressure, temperature, resistance, dimension or other
quality with a known figure for that measurement.
Disconnect To detach the connection between; to separate keyed or matched equipment parts.
Dismantle To take apart to the level of the next smaller unit or down to all removable parts.
Examine To perform a critical visual observation or check for specific conditions; to test the condition of.
Fit Correctly attach one item to another.
Inspect Review the work carried out by Specialists to ensure it has been performed satisfactorily.
Install To perform operations necessary to properly fit an equipment unit into the next larger assembly or
system.
Maintain To hold or keep in any particular state or condition especially in a state of efficiency or validity.
Operate Make sure that an item or system functions correctly as far as possible without the use of test
equipment or reference to measurement.
Readjust To adjust again; to move back to a specified condition; to bring back to an in-tolerance condition.
Reconnect To rejoin or refasten that which has been separated.
Refit Fit an item which has previously been removed.
Remove To perform operations necessary to take an equipment unit out of the next larger assembly or sys-
tem. To take off or eliminate. To take or move away.
Repair To restore damaged, worn out or malfunctioning equipment to a serviceable, usable or operable
condition.
Replace Remove an item and fit a new or a serviced item.
Reset To put back into a desired position, adjustment or condition.
Service To perform such operations as cleaning, lubricating and replenishing to prepare for use.
Test Ascertain by using the appropriate test equipment that a component or system functions correctly.
K0553 Revision C
ADTS542F/552F/553F/554F User Manual