Removing The Seat Cover For Cleaning - Maxi-Cosi Moda User Manual

Care and maintenance

Removing the seat cover for cleaning

• Seat trim may be removed for cleaning. Don't forget to remove the instruction manual.
• Tumble dry 10-15 minutes on low heat.
• Do not dry clean.
• All other surfaces should be cleaned with a mild soap and water.
• Never clean with bleach or spirit-type cleaners.
• Do not use the restraint without the cover.
• Check the webbing for fraying.
Remove trim for cleaning
SPLITTER
PLATE
J-CLAMPS
I I
36
Moda Convertible Car Seat
To remove headrest trim:
1. Move headrest to highest position.
2. Detach the headrest button holes from the plastic studs at
the back of the headrest.
3. Peel the trim off the headrest.
4. Remove Air Protect cells from headrest cover (x2).
IMPORTANT: Do not wash air protect cells. Ensure air
protect cells (x2) are removed from the headrest cover
before washing.
To replace headrest trim:
1. Move headrest to highest position.
2. Replace Air Protect in headrest cover.
3. Put the headrest trim on.
4. Attach to the 2 plastic studs at the back of the headrest
using the button holes.
To remove seat trim:
1. Loosen harness straps to allow some slack.
2. Release J-clamps on the back to gain access to the shoulder
straps, and undo from the splitter plate on the back of seat.
3. Pull straps through the front of the seat cover.
4. Remove the seat trim from the seat .
To replace seat trim:
1. Put the seat trim back on to the seat.
2. Feed the shoulder straps through the cover and attach
to splitter plate.
3. Attach the plastic J-clamps at the back.
NOTE: Ensure harness is not twisted.
I
Maxi-Cosi