Maxi-Cosi Moda User Manual page 31

Installation
3. Tighten the connector straps
Start with the strap on the inside closest to the centre
and remove as much slack out as possible.
Feed the free end of ISOGO strap through the side trim
opening.
Firmly push child restraint down into the vehicle seat
whilst pulling on the ISOGO straps.
Alternate removing the slack from side to side until you
get a firm fitment and achieve a
Ensure to pull the free end of the ISOGO strap out after
tightening complete.
NOTE: Always check for
at eye level.
GREEN
4. Attach top tether strap
Attach the top tether strap to the top anchorage point
in the vehicle.
Ensure there are no twists in the belt, and adjust until all
slack is removed from top tether.
IMPORTANT:
Do not attach the lower attachment connectors of two separate child restraints to
the same ISOFIX low anchorages in your car.
Always attach the top tether strap to the child restraint upper anchorage in your
car. Refer to your owner's manual.
Child restraint lower attachment connectors and the ISOFIX low anchorages in
your car are designed to withstand only those loads imposed by a correctly fitted
child restraint.
GREEN indication.
FEED
THROUGH
PULL
STRAP
Front of vehicle
REMOVE
I
Moda Convertible Car Seat
PUSH
I I
31
Maxi-Cosi