Maxi-Cosi Moda User Manual page 33

Installation
3. Tighten the connector straps
Start with the strap on the inside closest to the
centre
and remove as much slack out as possible, then move
to the outside strap and remove as much slack as
possible.
Firmly push child restraint down into the vehicle seat
whilst pulling on the ISOGO straps.
Alternate removing the slack from side to side until
you get a firm fitment and achieve a
indication.
NOTE: Always check for
at eye level.
GREEN
4. Attach top tether strap
Attach the top tether strap to the top anchorage
point in the vehicle.
Ensure there are no twists in the belt, and adjust until
all slack is removed from top tether.
IMPORTANT:
Do not attach the lower attachment connectors of two separate child restraints to
the same ISOFIX low anchorages in your car.
Always attach the top tether strap to the child restraint upper anchorage in your
car. Refer to your owner's manual.
Child restraint lower attachment connectors and the ISOFIX low anchorages in your
car are designed to withstand only those loads imposed by a correctly fitted child
restraint.
GREEN
PUSH
DOWN
PULL
Front of vehicle
I
Moda Convertible Car Seat
I I
33
Maxi-Cosi