Table of Contents
Advertisement
Vehicle information
Upper anchorage installation
Front of vehicle
Attachment bolt
Anchor fitting
Spacer(s)
(if required)
Vehicle trim
Vehicle metal
structure
FOR SEDANS ONLY:
200mm
min.
Centre line of
seating position
Attachment bolt
Anchor fitting
Spacer(s)
(if required)
Vehicle trim
Vehicle metal
structure
Reinforcing
washer
Lock washer
Nut
FOR CARS FITTED WITH A CHILD RESTRAINT
UPPER ANCHORAGE POINT:
Locate the upper anchorage point behind the rear
seating position (consult the car owner's handbook for
the location of the upper anchorage point).
Remove the thread plug from the parcel shelf/floor/
roof and install the attachment bolt as shown in
Figure 1.
CAUTION: DO NOT OVERTIGHTEN THE
ATTACHMENT BOLT. OVERTIGHTENING MAY
1
FRACTURE OR BREAK BOLT.
MAXIMUM TORQUE IS 20 Nm.
FOR CARS NOT FITTED WITH A CHILD RESTRAINT
UPPER ANCHORAGE POINT:
For sedans only:
Drill a 9mm diameter hole in the parcel shelf on the
centre-line of the seating position as shown in
Figure 2. Install the anchor bolt as shown in Figure 3.
It is recommended that this installation be carried out
by a child restraint fitting station or licenced motor
mechanic.
2
For vehicles other than sedans:
In Australia, consult your nearest child restraint fitting
station or traffic authority for vehicle inspection to
find the best, correct position for the placement of the
upper anchorage point, and for the correct attachment
bolt length and use of spacers. In New Zealand,
consult the agent for the vehicle.
3
I
Moda
Convertible Car Seat
I
I
17
Maxi-Cosi
Hide quick links:
Advertisement
Table of Contents
