Table of Contents
Advertisement
Installation
Rearward-facing using ISOGO
1. Set seat angle to "HIGH"
Push the red button, located on the front of the base
inwards and set seat angle to 'HIGH'.
Swing stabilising bar up into position.
2. Attaching ISOGO lower connectors
Release belt to full length by pressing grey button and
pulling adjuster. Repeat for both sides.
Locate low anchorage points. You can find this by
looking for the ISOFIX logo located on the vehicle seat.
Attach the lower connector on both sides. Listen for a
"click!"
NOTE: You can move the car seat out of the way
to locate and attach the connectors, then place
back into position before tightening.
NOTE: These images are for reference and illustration purposes only. We recommend
the use of the provided stabilising bar cover and the seat mat when installing
this product (if fitted).
I
I
30
Moda
Convertible Car Seat
I
Maxi-Cosi
(Newborn to 30 months approximately)
SWING UP
CLICK!
BOTH SIDES
HIGH
PUSH
& PULL
Hide quick links:
Advertisement
Table of Contents
