Putting Into Service; Power Supply - Ahlborn ALMEMO 2470-1S Operating Instruction

6. Putting into service

6. PUTTING INTO SERVICE
1. Connect the sensor to socket M0 (1). see Chapter 8
2. Power supply is via batteries, rechargeable battery pack, or mains adapter.
see 7.1, 7.3
3. Switch on by pressing
4. Select measuring channels by pressing key
values (5e). see 10.2.1
5. For relative measuring with respect to a reference value or for sensor ad-
justment press keys
keys ON , FCT
6. For differential measurement (2470-2/2S only), plug 2 sensors of same
type into sockets M0 and M1 and then select measuring point M4. see 10.8
7. To save individual measured value press key
8. For manual or cyclic measured value recording and saving to measured
value memory (2470-1S/2S only) press key
function ´ZY´ by pressing key
▲ ▼ ►
... see 9.3
/ , ,
9. Evaluating a measuring operation: To call up maximum / minimum values
press key MAX
and hold down key
Programming or data output via interface
Connect computer via interface cable to socket A1 or DC. see 12.1
Activate supplied software AMR-Control.
Via 'Setup interface' set the COM port and transmission rate to 9600 bauds.
Program the sensors via 'Program measuring point list'. Measured value dis-
play and sensor adjustment via ´Measuring points - Measured values´
Data logging on the computer :
Program the cycle via ´Devices - Programming´.
Open the terminal window via ´File - Terminal´.
´File - Terminal - Open log´, enter file name, ´Save´
Start measuring operation by means of command button 'Start'.
Stop measuring operation by means of command button 'Stop'.
´File - Terminal - Close log´
Call up file e.g. from MS-Excel and import using ´;´ as separator. see Man. 6.4.1

7. POWER SUPPLY

Power can be supplied to the measuring instrument in any of the following ways:
3 AA batteries (batteries or rechargeable NiMH batteries included in delivery)
USB interface cable with integrated power supply ZA 1919-DKUV
Mains adapter, 12 V, 1 A, with ALMEMO
14 ALMEMO 2470
ON (6). see 7.6
►
ON , . To return to normal measured value press
. see 10.5
FCT
or MIN (6). To delete maximum / minimum value(s) press
MAX or MIN
M▲
MEM
MEM
and enter cycle by means of keys
. see 10.3
® plug ZA 1312-NA7
(6); read out measured
(6). see 10.4
. see 11.2 Select cycle
,
PROG