Advertisement
Installation Instructions
Creating Vent Openings in the Mounting Backplate
Refer to Illustration 1.3 for these steps.
1.
Cut out the intake and exhaust openings in the mounting backplate. The openings must match the drive module vent
openings.
2.
Drill the 12 screw holes around the exhaust (top) vent openings and insert the 12 M5 X 12 pem studs.
3.
Drill the 12 screw holes around the intake (bottom) vent openings and insert the 12 M5 X 12 pem studs.
Illustration 1.3 Vent Dimensions for Mounting Plate
MI92J102
In-back/Out-back Cooling Kit for VLT®
Parallel Drive Modules
VLT® Series FC 102, FC 202, and FC 302
Danfoss A/S © 04/2016 All rights reserved.
3
Advertisement
Need help?
Do you have a question about the 176F6493 and is the answer not in the manual?
Questions and answers