Danfoss 176F6493 Installation Instructions Manual page 8

Installation Instructions
Installing the Back Panel Cover
1. Install a gasket (1) around each exhaust vent opening on the back side of the mounting backplate (4). Refer to
Illustration 1.7.
2. Install a duct spacer (2) onto each exhaust gasket and secure with 4 M5 nuts. Torque to 5.1 Nm (45 in-lb).
3. Install a gasket (5) around each intake vent opening on the back side of the mounting backplate (4).
4. Install an intake duct spacer (6) onto each intake gasket and secure with 4 M5 nuts. Torque to 5.1 Nm (45 in-lb).
5. Place a gasket (3) onto each exhaust duct spacer.
6. Place a gasket (7) onto each intake duct spacer.
Prepare the back panel cover. Refer to Illustration 1.8.
7.
7a Cut out the 2 intake and 2 exhaust vent openings in the back panel. The openings must match to the intake and
exhaust duct spacer openings.
7b Drill the 16 screw holes around the vent openings.
8. Secure the back panel cover to the frame.
9. Secure the back panel cover to the duct spacers with 16 M5x16 screws. Torque to 5.1 Nm (45 in-lb).
8
In-back/Out-back Cooling Kit for VLT®
Parallel Drive Modules
VLT® Series FC 102, FC 202, and FC 302
Danfoss A/S © 04/2016 All rights reserved. MI92J102