Removing/Installing Faceplate - Grizzly G0657 Owner's Manual

To remove the live center:
1. loosen the quill lock handle (if locked)
approximately half a turn counterclockwise.
2.
turn the quill handwheel counterclockwise
until the tailstock quill bottoms out, causing
the live center to be forced out of the quill.
The tailstock quill lock handle must always
be locked down while the lathe is in use. The
workpiece can be thrown from the lathe if
this step is not observed. Also, the tailstock
quill should not protrude from the tailstock
housing more than 2'' or the quill will not be
supported enough. failure to follow these
warnings may result in personal injury.
-24-
Removing/installing
faceplate
these instructions cover removing and installing
the faceplate. to mount a workpiece to your face-
plate, refer to faceplate Turning on Page 28.
To remove the faceplate:
1. disConneCt lathe FroM poWer!
2. hold the headstock spindle wheel securely
while turning the faceplate counterclockwise
until it is removed. if the spur center is
installed, it will be removed during this pro-
cess.
headstock
spindle wheel
figure 27. removing faceplate.
To install the faceplate:
1.
disConneCt lathe FroM poWer!
2.
thread faceplate onto spindle shaft until it is
secure against the shoulder on the spindle
shaft.
Models G0657/G0658 (Mfg. Since 5/13)
Faceplate