Inventory - Grizzly G0838 Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Inventory (Figures 5–7)
A. Lathe Assembly
—Headstock (mounted) ............................. 1
—Tool Rest Base (mounted) ...................... 1
—Tailstock (mounted) ................................. 1
—Faceplate 6" (installed) ........................... 1
Figure 5. Lathe assembly.
Model G0838 (Mfd. Since 10/17)
Qty
A
B. Stand Legs ................................................. 2
C. Machine Feet w/Hex Nuts .......................... 4
D. Tool Holder ................................................. 1
E. Knockout Tool ............................................. 1
F.
Spur Center MT#2 ...................................... 1
G. Live Center MT#2 ....................................... 1
H. Indexing Pin ................................................ 1
I.
Hex Wrenches 3, 4, 6, 8mm ..................1 Ea
J.
Hardware
—Cap Screws M10-1.5 x 35 ....................... 8
—Lock Washers 10mm .............................. 8
—Cap Screws M8-1.25 x 15 ....................... 2
—Lock Washers 8mm ................................ 2
Figure 6. Stand legs.
C
D
E
F
G
Figure 7. Loose inventory components.
B
H
I
-13-