Installing Faceplate - Grizzly G0844 Owner's Manual

Installing Faceplate

These instructions cover removing and installing
the faceplate. To mount a workpiece to your face-
plate, refer to Faceplate Turning on Page 27.
Tools Needed
Open-End Wrench 32mm .................................. 1
Hex Wrench 3mm .............................................. 1
Knockout Tool .................................................... 1
Removing Faceplate
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen (2) set
(see Figure 18).
3.
Insert included wrench over flats on spindle.
While holding spindle in place, turn faceplate
counterclockwise with knockout tool until
it is removed (see Figure 18). If the spur
center is installed, it will be removed during
this process.
1 of 2
Figure 18. Removing faceplate.
-22-
Qty
screws on faceplate
Faceplate
Installing Faceplate
1.
DISCONNECT MACHINE FROM POWER!
2.
Insert included wrench over flats on spin-
dle. While holding spindle in place, thread
faceplate clockwise onto spindle shaft until
secure against shoulder on spindle shaft.
3. Tighten/secure (2) set screws on faceplate
(see Figure 18).
To prevent faceplate and workpiece sepa-
rating from spindle during operation, head-
stock faceplate MUST be firmly threaded
onto spindle and secured in place by fully
tightening the two faceplate set screws.
If these instructions are not properly per-
formed, serious personal injury could occur.
Never resume turning operations without
making sure that index pin knob is disen-
gaged and spindle turns freely by hand.
Otherwise personal injury or property dam-
age could result.
Model G0844 (Mfd. Since 2/18)