Installing Faceplate - Grizzly G0733 Owner's Manual

Installing Faceplate

To install the faceplate:
1.
2.
Figure 26
Figure 26.
3.
4.
Figure 26
To prevent the faceplate and workpiece sep-
arating from the spindle during operation,
the headstock faceplate MUST be firmly
threaded onto the spindle and secured in
place by fully tightening the two faceplate
set screws. If these instructions are not
properly performed, serious personal injury
could occur.
Note: To remove the faceplate, disconnect the
lathe from the power source and perform the
steps above in reverse.
Changing Speed
Ranges
Figure 27.
Note: To maximize spindle torque, use the low
spindle speed range for spindle speeds of 1200
RPM or less.
Figure 28
Diameter Roughing
of Work- RPM
piece
Figure 28.
To change speed ranges:
1.
Figure 27
General Finishing
Cutting RPM
RPM