Installing/Removing Tailstock Center - Grizzly G0838 Owner's Manual

Removing Headstock Center
1.
DISCONNECT MACHINE FROM POWER!
2.
Hold a clean rag under spindle or wear leath-
er glove to catch center when you remove it.
3.
Insert knockout tool through outbound end of
spindle and firmly tap back of center, catch-
ing it as it falls, as shown in Figure 21.
Knockout Tool
Figure 21. Example of removing headstock
center with knock-out tool.
-24-
Installing/Removing
Tailstock Center
The included live center installs into the tailstock
quill with an MT#2 tapered fit.
Item Needed
Leather Glove/Clean Rag .................................. 1
Installing Tailstock Center
1. Loosen quill lock handle, and rotate
handwheel until quill extends about 1", as
shown in Figure 22.
Handwheel
Figure 22. Example of installing center into
tailstock quill.
2.
Make sure mating surfaces of center and
quill are free of debris and oily substances
before inserting center to ensure a good fit
and reduce runout.
3. Firmly insert tapered end of center into
tailstock quill, as shown in Figure 22.
4. Make sure center is securely installed by
attempting to pull it out by hand—a properly
installed center will not pull out easily.
Model G0838 (Mfd. Since 10/17)
Qty
Quill Lock Handle
Quill