The Demonstration Program; Powering Down; Emergency Shutdown - Snap-On Modis Ultra User Manual

Getting Started

3.3 The Demonstration Program

A Scanner demonstration program allows you to become familiar with many of the test capabilities
of the Scanner module without actually connecting to a vehicle.
z
To start the demonstration program:
1. From the Home screen, tap the Scanner icon.
The manufacturer menu, which lists all of the makes available for testing, displays.
2. Tap the Demonstration button, which is included on the manufacturer menu.
3. A screen advising you are in simulation mode displays, select Continue.
IMPORTANT:
Do not connect a vehicle to the diagnostic tool while in the Demonstration mode.
4. Follow the on-screen instructions and select as needed until the confirmation screen displays.
5. Select OK on the confirmation screen to load the demonstration database.
6. Select OK from the Demo mode message screen.
A systems menu, which shows all of the systems available for testing, displays.
7. Select from any of the systems listed, then select from the submenus.

3.4 Powering Down

Use the Power key to turn the diagnostic tool off.
IMPORTANT:
All vehicle communication must be terminated before shutting down the diagnostic tool. A warning
message displays if you attempt to shut down while the Scanner is communicating with the
vehicle. Forcing a shut down while communicating may lead to ECM problems on some vehicles.
z
To power off the unit:
1. Press N/X or Back until you reach the Home screen.
A "stopping communication" message appears briefly before the Home screen displays.
2. Disconnect the Scanner Data Cable from the vehicle test connector.
3. Press the Power key.
The Turn off dialog box displays.
4. Press Y/a or OK to turn the power off, or press N/X or Cancel to test a different vehicle.

3.4.1 Emergency Shutdown

In case of emergency, press and hold the Power key for five seconds to force a shutdown.
15
The Demonstration Program