3Com VCX Connect Installation And Configuration Manual page 62

62 A C: S
PPENDIX AMPLE
--------------------- Configuring IP Interface 'eth0' ---------------------
IP Address
Network Subnet Mask
Default Gateway Address
------------------------- Configuring DNS Servers -------------------------
Enter DNS servers one at a time.
When done, enter 0.0.0.0 to stop.
Primary DNS Server
Secondary DNS Server
Tertiary DNS Server
----------------------- Configuring DNS Search Path -----------------------
Press Enter to leave the current path unchanged, or specify
a new search path, with spaces separating each entry.
DNS Search Path : localdomain
-------------------- Configuring Network Time Protocol --------------------
Enter NTP servers one at a time.
If your organization or ISP does not have an NTP server, consider using the
public NTP servers provided by pool.ntp.org; see http://www.pool.ntp.org
for more information.
When done, enter a blank entry or 0.0.0.0 to stop.
Primary NTP Server
Secondary NTP Server
Tertiary NTP Server
C S
ONFIGURATION CRIPTS
VCX Connect servers have factory configured default hostnames (vcxpri
and vcxsec). You can change these hostnames if you want, but changes
are not required.
: 192.168.1.190
: 255.255.255.0
: 192.168.1.254
Change the IP Address, Network Subnet Mask and Default Gateway
Address values to conform to the network segment on which the server
will reside. To change a value, use the backspace key to delete the current
value, and then enter the new value in the same format.
:
:
: 0.0.0.0
Enter up to three IP addresses, one for each DNS server that you want the
VCX Connect server to know about.
Replace this string with the search path appropriate for you company and
the network segment on which the VCX Connec server will reside. For
exmple, 3Com Corporation uses the search path ne.3com.com for servers
that are located in the New England (ne) area of the US.
When done, enter a blank value or 0.0.0.0.
: 0.pool.ntp.org
: 1.pool.ntp.org
: 2.pool.ntp.org