Moving The Vcx Connect Server And Media Gateways; Installing A License Key; Changing Default Passwords; System Configuration - 3Com VCX Connect Installation And Configuration Manual

26 C 2: VCX™ C
HAPTER
S I
ONNECT ERVER NSTALLATION

Moving the VCX Connect Server and Media Gateways

1 Shut down the primary server and disconnect all cabling.
2 If you are using a VCX Connect 200 server, shut down the separate media
gateways by removing the power cord from the chassis, move the media
gateways to their final location, and reconnect them to power and to the
network segment on which they will operate.
3 Move the primary server to its final location and reconnect it to power
and to the network segment on which they will operate.
4 Start the primary server and wait for approximately 5 minutes for the
boot process to be completed.

Installing a License Key

VCX Connect 100 and VCX Connect 200 servers come from the factory
with pre-installed licenses to support:
25 telephone users
25 voice mailboxes
If you obtained additional licenses, install the license key on the primary
server. For instructions on how to obtain a license key, see:
VCX Installation Guide > Pre-Installation Guidelines > License Keys

Changing Default Passwords

To change the default passwords for the app, cworks, oracle, root,
tomcat, and vcx accounts, log in to the server and run the vcx-reconfigure
script. Accept the default answers for all prompts that are not related to
passwords, and, when prompted for the account passwords, change the
default values.

System Configuration

Your VCX Connect system is now configured to communicate in an IP
network. The next steps are described in these sections:
"IP Telephony Configuration"
"IP Messaging Configuration"
"Additional Configuration Steps"
on page 40
on page 42
on page 43