3Com VCX Connect Installation And Configuration Manual page 19

Installing a Primary and Secondary Pair of VCX Connect Servers
3 Start the primary and secondary servers and wait for approximately 5
minutes for the boot process to be completed.
4 Using one of the connection methods outlined in
VCX Connect Server"
the root account.
Primary Server Default IP Address: 192.168.1.190
Default Password (root account): pvadmin
CAUTION: 3Com strongly recommends that, for security reasons,
customers change the default passwords on these VCX accounts:
app
cworks
oracle
root
tomcat
vcx
Instructions on how to change these account passwords are found later
in this section. See
5 On the primary VCX Connect server, run the
script (see
-wizard
these network parameters to correspond to the network location in
which you intend to install the server:
IP address
Subnet mask
Default gateway address
Primary, secondary, and tertiary DNS server IP addresses
DNS search path
Primary, secondary, and tertiary NTP (time) server IP addresses
Time zone and geographic location information
After you finish, the script may display an error message indicating that
the Network Time Protocol (NTP) server(s) could not be reached. You can
safely ignore this message. The VCX Connect server is not yet connected
to the network and therefore cannot contact the NTP server(s).
on page 14, access the primary server and log in to
"Changing Default Passwords"
"Networking Sample Script"
"Accessing a
on page 22.
vcx-config-network
on page 55) and change
19