To Disable The User Code; To Enable The User Code; To Delete The User Code - Securam SafeLogic Basic Operating Instructions


Press button "1". One beep will sound, indicating that the system is ready to receive the new
User Code

Enter a six digit code. Two beeps will sound.

Repeat the six digit code. One beep will sound, indicating that the six digit codes entered were
the same and the addition of the User Code was successful.

If 3 beeps sound, the programming attempt was unsuccessful. Repeat the steps above.
Notes:

If Three Beeps sound, the code change process has been unsuccessful and the existing code
is still valid. Repeat code change steps above.

Verify the new code at least 3 times to ensure the code has been programmed correctly.

The system will revert to standby status if there is no key press within 10 seconds. Standby
status is indicated by two short beeps.

To Disable the User Code


Enter the Manager Code and hold down the last digit of this code. One beep will sound
indicating a valid code entry. Continue to hold down this digit until two additional beeps sound.
This indicates that the system is now in program mode.

Press button "2". One beep will sound, indicating that the system has disabled the User Code.

To Enable the User Code


Enter the Manager Code and hold down the last digit of this code. One beep will sound
indicating a valid code entry. Continue to hold down this digit until two additional beeps sound.
This indicates that the system is now in program mode.

Press button "1". One beep will sound, indicating that the system has enabled the User Code

To Delete the User Code


Enter the Manager Code and hold down the last digit of this code. One beep will sound
indicating a valid code entry. Continue to hold down this digit until two additional beeps sound.
This indicates that the system is now in program mode.

Press button "3". One beep will sound, indicating that the system has deleted the existing User
Code

Now follow the "To Add the User Code "instruction if you wish to program a user
.
Default User Code
Default Manager Code
Your User Code
Your Manager code
1 2 3 4 5 6
1 1 1 1 1 1