Computer - Exerpeutic Folding Upright Bike with Pulse Owner's Manual

ASSEMBLY
TOOL
5mm Allen Wrench with
Phillips Screwdriver
1PC
Figure C Figure D
Step 4
Remove four Screws (75) from the Console (9) first.
4A Installing the Handlebar: Place the Handlebar (4) onto the Front Frame (1), Secure the
Handlebar (4) onto the Front Frame (1) with four Flat Washers (33) and four Hexagon Socket
Bolts (58). Tighten the Bolts (58) with the 5mm Allen Wrench with Philips Screwdriver
provided.
4B Connecting the Computer Wire to the Sensor Wire: Connect the Hand Pulse Sensor (9A)
to the Hand Pulse Sensor Wire (79). See Figure C. Connect the Computer Wire (9B) to the
Sensor Wire (13). See Figure D. Attach the Console (9) onto the Handlebar (4) and secure with
four Screws (75) that were previous removed. Tighten the Screws (75) with the 5mm Allen
Wrench with Philips Screwdriver provided.
PRE-INSTALLED HARDWARE
(33) Flat Washer
(58) Hexagon Socket Bolt
4PCS
4PCS
12