Installing the E-MSM720
Installation Procedures
W A R N I N G
C a u t i o n
2-8
Wall or Under-Table Mounting
You can mount the E-MSM720 on a wall with either the front or rear panel
facing up.
The network ports must be facing up. Do not mount the E-MSM720
with ports facing down.
The E-MSM720 should be mounted only to a wall or wood surface that is at
least 1/2-inch (12.7 mm) plywood or its equivalent.
1.
Use a #1 Phillips (cross-head) screwdriver and attach the mounting
brackets to the E-MSM720 with the included 8-mm M4 screws.
2.
Attach the E-MSM720 to the wall or wood surface with two 5/8-inch
number 12 wood screws (not included).
Wall
Figure 2-5. Wall Mounting the E-MSM720
Horizontal Surface Mounting
Place the E-MSM720 on a table or other horizontal surface. The E-MSM720
comes with rubber feet in the accessory kit that can be used to help keep the
E-MSM720 from sliding on the surface.
RJ-45 Ports
5/8-inch
wood screws