2 Installing
WARNING!
in accordance with local electrical code and regulations.
It is recommended that you mount the controller only after performing the procedures in this guide
and familiarizing yourself with the product.
For table-top installations, attach the rubber feet to the bottom corners.
For rack or wall mounting, you can order the optional part: HP MSM710 Controller Rack
Mounting Kit, part number J9404A.
Mounting in a rack
For standard 48 cm (19-inch) rack mounting first attach a mounting bracket to each side of the
controller using the provided screws, and then mount it in the rack.
Mounting directly on a wall
Attach the controller to a wall so that the front faceplate (with status lights) faces the ceiling, the
Ethernet ports face the floor, and the top of the unit is flat against the wall. Do this as follows:
1.
Rotate the mounting bracket 90 degrees (from how it is used for rack mounting) and attach it
to the two screw holes along the bottom edge of the controller.
2.
Drill holes in the wall and insert appropriate wall anchors (not supplied) according to their
directions. The anchors must support at least 2.2 kg (5 pounds). Allow extra weight for cables.
3.
Fasten the controller to the wall anchors using the screws supplied with the anchors. If needed,
use washers on top of the bracket.
This is a general procedure. It is the installer's responsibility to perform the installation
Mounting in a rack
7