Table of Contents
Advertisement
2. When the log is supported on one end (Fig. 21), cut 1/3 the diameter from the
underside (under buck). Then make the finished cut by over-bucking to meet the
first cut.
3. When the log is supported on both ends (Fig. 22), cut 1/3 the diameter from the
top (over buck). Then make the finished cut by under bucking the lower 2/3 to meet
the first cut.
4. When bucking on a slope always stand on the uphill side of the log (Fig. 23). When
"cutting through", to maintain complete control release the cutting pressure near
the end of the cut without relaxing your grip on the product handles. Don't let the
chain contact the ground. After completing the cut, wait for the saw chain to stop
before you move the product. Always stop the motor before moving from tree to
tree.
Fig. 21
Fig. 22
Fig. 23
29
Advertisement
Table of Contents
