Table of Contents
Advertisement
4. Place the saw chain around the sprocket (the part with remark-1) while lining up
the slot in the guide bar with the internal bolt (the part with remark-2) at the base
of the saw and the chain tensioning pin (the part with remark-3) in the guide bar's
pin hole. The chain tensioning pin may need adjustment to properly align with the
hole in the guide bar. Use the chain tensioning wheel (the part with remark-4) to
adjust its location until it fits in the guide bar.
5. Turn the chain tensioning wheel to preliminarily tighten the guide bar enough that
it stays in place. While holding the bar still, place the cover back onto the saw.
Make sure the tab properly lines up with the slot on the body of the saw (See Fig.
4). Lock the cover in place with the cover locking knob by turning it clockwise until
it engages.
Fig. 2
2 3
Fig. 3
Fig. 4
19
Advertisement
Table of Contents
