Table of Contents
Advertisement
Replace the chain
1. Rotate the bar adjustment locking knob and remove the cover of the saw's body
(see pages 18-19 for more information).
2. Lift the worn saw chain out of the fitted slot in the guide bar.
WARNING! When handling saw chains, always wear protective gloves.
3. Place the new chain in this position, making sure the teeth are facing the correct
direction and that the edge of the chain fits into the slot around the guide bar. (See
Fig. 8).
4. Replace the cover. Adjust tension before operating.
Filling the auto oil system
This chainsaw features an auto-oiling system to keep the chain and guide bar
properly lubricated. The oil level indicator shows the remaining oil in the chainsaw. If
the oil level decreases to below one quarter capacity, refill it with the proper bar and
chain oil. To fill the oil reservoir:
1. Remove the oil cap. Fill the reservoir with bar and chain oil until the oil level has
reached full capacity.
2. Put the oil cap back on. Make sure to check the oil level after every 10 minutes of
use. Unplug the chainsaw before checking oil levels or filling the oil reservoir.
Charge the battery
The battery is not fully charged at the time of purchase. Before using the chainsaw
for the first time, place the battery in the charger by sliding it into a locked position
until it clicks and charge it fully. (See Fig. 9)
Fig. 8
Fig. 9
21
Advertisement
Table of Contents
