Advantech-DLoG DLT-V6210 Safety Instructions page 4

Install an easily accessible disconnecting

device close to the device.
Make sure that the disconnecting device

disconnects all power supply lines.
To ensure the IP protection: Mount the
cable cover.
Before commissioning, install the supplied

cable cover for external connections.
Observe the information in the "DLT-

V6210 Manual" and in the "DLT-V6210
Quick Start Guide".
Radio wave emission in the vicinity of
persons.
To ensure that the limits set for exposure to
radio waves are not exceeded:
Install the DLT-V6210 so that persons

maintain a minimum distance of 20 cm to
the antenna.
Observe the applicable regulations for

your deployment location/country with
regard to frequencies and the maximum
permissible transmitting power.
Responsibility for this lies with the
company operating the DLT-V6210. The
regulatory authorities in the relevant
country can provide information on this.
Electromagnetic radio frequency energy
can interfere with technical devices.
Do not use the DLT-V6210 near

pacemakers.
Before using it please obtain information

about the use of DLT-V6210 within certain
areas (e.g. airports, hospitals, etc.) and
respectively applicable regulations, also
obtain an approval for the operation, if
necessary.
Page 4 / 8 Safety instructions DLT-V6210, V1.00, PN 2005621030
Safety Instructions
DLT-V6210 Industrial PC
NOTICE: Physical damage
Installation environment without cooling
air can overheat / damage the DLT-V6210.
The DLT-V6210 employs a passive cooling
concept whereby the waste heat generated
inside the device is emitted from the surface
of the housing. For this system to function
properly, sufficient fresh air circulation is
required.
Never install the system in a closed

environment where the cooling air is
unable to dissipate accumulated heat to
the outside.
The maximum permissible ambient

temperature for the entire system needs
to be taken into account for the specific
application area.
Observe the following when connecting /
removing external devices.
Only use accessories that have been

tested and approved by Advantech-DLoG
for the respective DLT-V6210.
The DLT-V6210 may not be connected to

the power supply if external devices are
connected / removed. Otherwise
considerable damage could be caused to
both the DLT-V6210 and the peripheral
devices
Make sure that peripherals with their own

power supply are either switched on at
the same time as the DLT-V6210 or after
the start of DLT-V6210.
Otherwise, you must ensure that a

backflow from the external device to
the DLT-V6210 system cannot take place.
Only power up the DLT-V6210 when all

devices have been connected and
the DLT-V6210 has been closed correctly
 DLoG GmbH, 2016