Table of Contents
Advertisement
Chapter 5
Diagnostics
This chapter describes:
•
•
•
5.1 Status Data
The GGC001 produces a total of 64 bits (8 bytes) to supply status information to the controlling
PROFINET Controller. When ultimately controlled by an RX3i PLC, these reference bits consume
a total of 64 reference address bits in %I memory. The 64 bits consist of
•
•
Each bank of 32 bits may be assigned a different set of Input reference addresses in RX3i
memory.
For each bank of 32 status bits, a default beginning reference (the next available %I) for the
status bits is automatically assigned by Proficy Machine Edition (PME). These assignments may
be changed by clicking on the GCG001 and keying in different %I references.
5.1.1 PROFINET Status Data
For the Genius Gateway GCG001, the thirty-two bits in the PROFINET Status Data are
organized as follows, beginning at the first %I status reference assigned to this bank of 32:
GFK-2892B
Status Bits
Genius Status Bits for Genius Gateway
o
PROFINET Status Bits for Genius Gateway
o
Module LED Indicators
Power-up
Module Restart
o
Problems During Power-up and Reset
o
Transitioning from Firmware Update Mode to Normal Operating Mode
o
32 bits related to the operation of the GCG001 itself referred to in PME as "Gateway
Status Data" and
32 bits related to the operation of the Genius bus which it controls – referred to as
"Genius Status Data" in PME.
Figure 21: Gateway Status Data
PACSystems RX3i Genius Communications Gateway User Manual
Chapter 5. Diagnostics
Public 37
Advertisement
Table of Contents
