Table of Contents
Advertisement
Chapter 2
Installation
This chapter provides instructions for installing the module. The following topics are covered.
•
•
•
•
•
For additional information about RX3i system installation, see the PACSystems RX3i System
Manual, catalog number GFK-2314.
For additional information about PROFINET installation and configuration, see GFK-2571 for
the RX3i PROFINET Controller. You will also need Proficy Machine Edition (PME) configuration
and programming software, version 8.0 or later.
2.1
Pre-Installation Check
Upon receiving your RX3i equipment, carefully inspect all shipping containers for damage. If
any part of the system is damaged, notify the carrier immediately. The damaged shipping
container should be saved as evidence for inspection by the carrier.
As the consignee, it is your responsibility to register a claim with the carrier for damage
incurred during shipment. GE Intelligent Platforms will cooperate fully with you, however,
should such action be necessary.
After unpacking the RX3i equipment, record all serial numbers. Serial numbers are required if
you should need to contact Customer Care during the warranty period. All shipping containers
and all packing material should be saved should it be necessary to transport or ship any part
of the system.
Verify that all components of the system have been received and that they agree with your
order. If the system received does not agree with your order, contact Customer Care.
If you need technical help, contact Technical Support. For phone numbers and email
addresses, see the Contact Information page in the front of this manual.
2.2 Installation Location
This product is primarily intended for use with the RX3i system. Its components are considered
open equipment (having live electrical parts that may be accessible to users) and must be
installed in an ultimate enclosure that is manufactured to provide safety. At a minimum, the
enclosure shall provide a degree of protection against solid objects as small as 12mm (e.g.
fingers). This equates to a NEMA/UL Type 1 enclosure or an IP20 rating (IEC 60529) providing at
least a pollution degree 2 environment. For details about installing RX3i rack systems, refer to
GFK-2314, PACSystems RX3i System Manual.
GFK-2892B
Pre-Installation check
Module installation and removal
Port connections
LED indications
Firmware updates
PACSystems RX3i Genius Communications Gateway User Manual
Chapter 2. Installation
Public 19
Advertisement
Table of Contents
