Kioti KL701 Manual page 42

9- KL701
LUBRICATION AND MAINTENANCE
Do not perform any service or maintenance Opera-

tions with loader raised off the ground. For addition-
al access to tractor components remove loader.
Lower the loader to the ground and relieve pres-

sure in loader hydraulic lines prior to perform-
ing any service or maintenance operations on the
tractor or loader.
Escaping fluid under pressure can have sufficient

force to penetrate the skin, causing serious inju-
ry. Before disconnecting lines, be sure to relieve
all pressure. Before applying pressure to the sys-
tem, be sure all connections are tight and that
lines, pipes and hoses are not damaged.
Fluid escaping from a very small hole can be al-
most invisible. Use a piece of cardboard or wood
rather than your hands to search for suspect-
ed leaks. If injured by escaping fluid, seek medi-
cal attention immediately. Serious infection or re-
action can develop if correct medical treatment is
not administered immediately.
Refer to "Lubrication and Maintenance Chart" for quick
reference to Maintenance Operations.
KL701-AU-09.indd 2
CAUTION
IMpORTANT
CAUTION
WARNING
Do not operate the loader if the fittings are leaking

or if the hoses are damaged. A sudden line burst
could cause the mainframe to drop suddenly, caus-
ing damage to the tractor or loader or injury to per-
sonnel.
Operate the loader from the tractor seat only.

Do not stand or walk under a raised loader. Acci-

dental movement of control lever or leak in hydrau-
lic system could cause mainframe to drop, causing
severe injury.
Check the tractor hydraulic system as outlined in the
Tractor Operator's Manual.
NOTE
When checking hydraulic system oil level, the

loader should be on the flat land and bucket fully
retracted (all cylinders in retracted position)
Grease all loader pivot points daily (10 hours). Re-

fer to Tractor Operator's Manual for lubricant rec-
ommendations.
Inspect hydraulic hoses, connections, control

valve and cylinders for evidence of leakage.
Tractor tires should be maintained at maximum

recommended inflation to maintain normal tire
profile with added weight of loader/material. Un-
equal rear tire inflation can result in bucket not
being level to the ground.
2013-03-29 오전 11:28:27